The following example activates an operation time range (named "morning") on port gi1/0/1. While the port is in shutdown because of other reasons, this The port stays up and at which time the port will be shutdown. This command defines the time frame during which The operation time command influences the port if the port status is up. It is recommended to disable spanning tree or to enable spanning-tree PortFast mode on 802.1x edge ports (ports in auto state that are connected to end stations), in order to proceed to the forwarding state immediately after successful authentication. Interface (Ethernet, Port Channel) Configuration mode User Guidelines There is no time range configured on the port authorized state. When the Time Range is not in effect, the port is shutdown. Time-range-name-Specifies a time range the port operates (in up state). To cancel the time range for the port operation time, use To control the time that the port is up, use the operation time Interface (Ethernet, Port Channel) Configuration mode command. If the switch shuts down a port channel it additionally shuts down all ports of the port channel too.Įxample 1-The following example disables gi1/0/4 operations.Įxample 2-The following example restarts the disabled Ethernet port.Įxample 3-The following example shuts down vlan 100.Įxample 4-The following example shuts down tunnel 1.Įxample 5-The following example shuts down Port Channel 3.
#Enable a master out loopback windows 10 mac#
If the switch shuts down an Ethernet port it additionally shuts down the port MAC sublayer too. If you shut down a VLAN, on which an IP interface is configured, bridging into the VLAN continues, but the switch cannot transmit The DOWN state of ifOperStatus means that the interface does not transmit/receive messages from/to higher levels. When ifAdminStatus is changed to DOWN, ifOperStatus The shutdown command set a value of ifAdminStatus (see RFC 2863) to DOWN. Interface Configuration mode User Guidelines This command has no arguments or keywords. To restart a disabled interface, use the no form of this command. To disable an interface, use the shutdown Interface Configuration mode command. If the command returnsĪn error on one of the interfaces, it does not stop the execution of the command on other interfaces.Įxample switchxxxxxx(config)# interface range gi1/0/1-4 Interface (Ethernet, Port Channel, VLAN) Configuration mode User GuidelinesĬommands under the interface range context are executed independently on each interface in the range. The interface ID can be one of the following types: Ethernet port, VLAN, or port-channel Interface-id-list-Specify list of interface IDs. Interface range interface-id-list Parameters To execute a command on multiple ports at the same time, use the interface range command.
The interface ID can be one of the following types: Ethernet port, port-channel, VLAN, range, To enter Interface configuration mode in order to configure an interface, use the interface Global Configuration mode command. This chapter contains the following sections:
IP Routing Protocol-Independent Commands.
0 kommentar(er)
